[Previous][Next]
INITIALISATION PROCEDURE FOR LEARNING VALUE IN MFI ENGINE
 
 
Initialise learning values in the MFI engine when one of the following service operations is performed.
  • At replacing engine assembly.
  • At replacing and cleaning injector.
  • At replacing and cleaning throttle body.
  • At replacing knock sensor.
 
 
 
INITIALISATION PROCEDURE
1. After the power supply mode of the electric motor switch is OFF, connect the scan tool (M.U.T.-III SE) to the data link connector.
2. Operate the electric motor switch without depressing the brake pedal and turn the power supply mode of electric motor switch to ON.
3. Select "ENGINE" from System select Screen of the scan tool (M.U.T.-III SE).
4. Select "Special Function" from ENGINE Screen.
5. Select "Learned value reset" from Special Function Screen.
6. Initialise the learning value by pressing the "OK" button.