[Previous][Next]
DTC Diagnosis Procedure
 
 
1.CHECK CONNECTOR
  1. Turn the ignition switch OFF.
  2. Check the terminals and connectors of the side radar LH/RH for damage, bend and short (unit side and connector side).
Is the inspection result normal?
.
Repair the terminal or connector.
 
2.CHECK CONTINUITY OF RIGHT/LEFT SWITCHING SIGNAL CIRCUIT
  1. Disconnect side radar LH/RH connector.
  2. Check continuity between side radar LH/RH harness connector and ground.
Side radar LHGroundContinuity
ConnectorTerminal
B46111Yes
Side radar RHGroundContinuity
ConnectorTerminal
B4625Yes
11
Is the inspection result normal?
Inspection End.
Repair harness or connector.