DTC Description

DTC DETECTION LOGIC

DTC No.		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
U2A03	88	CAN comm error (Controller area network communication error)	1	Diagnosis condition	When ignition switch is ON.
				Signal (terminal)	CAN communication signal
				Threshold	Not transmitting.
				Diagnosis delay time	2 seconds or more
			2	Diagnosis condition	When ignition switch is ON.
				Signal (terminal)	CAN communication signal
				Threshold	Not receiving.
				Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

The following functions are suspended.^*

Intelligent trace control function
Active ride control function
Automatic brake hold function
Drive mode selector function

*: Depends on the DTC detection status

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

2.CHECK DTC DETECTION

With M.U.T.-III SE

Ignition switch OFF to ON.
caution Be sure to wait of 10 seconds after ignition switch OFF or ON.
Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “U2A03-88” detected?

Refer to Diagnosis ProcedureDiagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END