[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C1F05 49 Front camera unit
(Front camera unit)
Diagnosis condition When engine is running
Signal (terminal)
Threshold If front camera unit is malfunctioning
Diagnosis delay time 1 second or less
noteDTC "C1F05-49" may be detected when M.U.T.-III SE is communicating with ABS actuator and electric unit (control unit) since the control function of ABS actuator and electric unit (control unit) is temporary stopped.
 
 
POSSIBLE CAUSE
Front camera unit
 
 
FAIL-SAFE
The following systems are canceled.
  • Vehicle-to-vehicle distance control mode
  • Conventional (fixed speed) cruise control mode
  • Steering wheel assistance function
  • AEB
  • LDW
  • LDP
  • Active Blind Spot Assist [ABSA]
  • TSR
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Perform “Diagnosis (One System)” of "ACC/ADAS 2" with M.U.T.-III SE.
    noteWhen performing "Read All DTCs", DTC “C1F05-49” may be detected because ABS actuator and electric unit (control unit) stops its control function by communicating with M.U.T.-III SE. Therefore performing "Diagnosis (One System)" is necessary.
  3. Check if the “C1F05-49” is detected as the current malfunction in “Self Diagnostic Result” of “ACC/ADAS 2”.
Is “C1F05-49” detected as the current malfunction?
Refer to DTC Diagnosis ProcedureDiagnosis Procedure .
-1 To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2 Confirmation after repair: INSPECTION END