[Previous][Next]
Diagnosis Procedure
1.CHECK CHASSIS CONTROL MODULE IGNITION POWER SUPPLY
  1. Ignition switch OFF.
  2. Disconnect the chassis control module harness connector.
  3. Check the voltage between chassis control module harness connector and ground.
    +Voltage
    Chassis control module
    ConnectorTerminal
    B365GroundApprox. 0 V
  4. Ignition switch ON.
  5. Check the voltage between chassis control module harness connector and ground.
    +Voltage
    Chassis control module
    ConnectorTerminal
    B365Ground6 − 16 V
Is the inspection result normal?
.
.
 
2.CHECK CHASSIS CONTROL MODULE IGNITION POWER SUPPLY CIRCUIT
  1. Ignition switch OFF.
  2. Check the 10A fuse (#40).
  3. Check continuity between chassis control module harness connector and the fuse block (J/B).
    Chassis control moduleFuse block (J/B)Continuity
    ConnectorTerminalConnectorTerminal
    B365B317PExisted
Is the inspection result normal?
Perform trouble diagnosis for ignition power supply.
Repair / replace harness, connector, or fuse.
 
3.CHECK CHASSIS CONTROL MODULE BATTERY POWER SUPPLY
Check voltage between chassis control module harness connector and ground.
+Voltage
Chassis control module
ConnectorTerminal
B3613Ground6 − 16 V
.
.
 
4.CHECK CHASSIS CONTROL MODULE BATTERY POWER SUPPLY CIRCUIT
  1. Check the 5A fuse (#11).
  2. Check continuity between chassis control module harness connector and the fuse block (J/B).
    Chassis control moduleFuse block (J/B)Continuity
    ConnectorTerminalConnectorTerminal
    B3613B328QExisted
Is the inspection result normal?
.
Perform the trouble diagnosis for 12V battery power supply circuit.
 
5.CHECK CHASSIS CONTROL MODULE GROUND CIRCUIT
Check the continuity between chassis control module harness connector and the ground.
Chassis control moduleContinuity
ConnectorTerminal
B3615GroundExisted
Is the inspection result normal?
.
Repair / replace harness or connector.
 
6.CHECK TERMINAL
Check the chassis control module terminals for damage or loose connection with harness connector.
Is the inspection result normal?
INSPECTION END
Repair or replace error-detected parts.