Diagnosis Procedure
1.
CHECK BSW INDICATOR CIRCUIT FOR SHORT
Turn ignition switch OFF.
Disconnect side radar RH harness connector and BSW indicator harness connector.
Check continuity between side radar RH harness connector and ground.
Side radar RH
Ground
Continuity
Connector
Terminal
B462
6
Not existed
Is the inspection result normal?
.
Repair the harnesses or connectors.
2.
REPLACE THE SIDE RADAR
Replace the side radar.
Perform “Read All DTCs” with M.U.T.-III SE.
Check if the “C1E81-12” is detected in “Self Diagnostic Result” of “Side radar (Rear right)”
Is the DTC “C1E81-12” detected?
Replace the side radar RH. Refer to
Removal and Installation
.
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
. 
Repair the harnesses or connectors. Replace the side radar RH. Refer to Removal and Installation. INSPECTION END