[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2A1F-16Camera power supply
(Camera power supply)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)Camera power supply
Threshold0 V
Diagnosis delay time30 seconds or more
 
 
POSSIBLE CAUSE
  • LVDS cable (between multi-around monitor control unit and each camera)
  • Multi-around monitor control unit
 
 
FAIL-SAFE
  • Camera image not displayed
  • MOD (Moving Object Detection) function is stopped.
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait for 30 seconds.
  3. Turn ignition switch ON and wait at least 1 minute or more.
  4. Select “Self Diagnostic Result” mode of “Multi Around Monitor” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2A1F-16 detected?
Proceed to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END