[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2A05–55Multi-around monitor control unit
(Multi-around monitor control unit)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)—
ThresholdConfiguration is incomplete
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
Vehicle specifications for multi-around monitor control unit is incomplete
 
 
FAIL-SAFE
  • On applicable camera screen marking (Red) is displayed.
  • MOD (Moving Object Detection) function is stopped.
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “Multi Around Monitor” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2A05–55 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END