If only the multi-around monitor control unit is replaced, the calibration data stored in the camera can be written to the multi-around monitor control unit.
WORK PROCEDURE
1.WRITE CALIBRATION DATA
With M.U.T.-III SE
Select "CALIBRATING CAMERA IMAGE" of "Special Function" mode using M.U.T.-III SE.
After displaying the status, check that the status is displayed as "Normal".
Is the status of each camera displayed as "Normal"?
INSPECTION END
Calibrate the camera that is not displayed as "normal". Refer to Work Procedure.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
With M.U.T.-III SE
INSPECTION END
Calibrate the camera that is not displayed as "normal". Refer to Work Procedure
.