[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen items (Trouble diagnosis content)DTC detection condition
B272B-16CENTER SENSOR [FR]
(Center sensor [FR])
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)Front sonar sensor RH inner power supply
ThresholdMore than 27 V
Diagnosis delay time4 seconds or more
 
 
POSSIBLE CAUSE
  • Harness and connector between sonar control unit and front sonar sensor RH inner
  • Sonar control unit
 
 
FAIL-SAFE
Stop the obstacle detection function
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “SONAR” using M.U.T.-III SE.
  5. Check the DTC.
Is DTC “B272B–16” detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END