[Previous][Next]
Diagnosis Procedure
1.CHECK FRONT SONAR SENSOR SIGNAL RH OUTER CIRCUIT (OPEN)
  1. Turn ignition switch OFF.
  2. Disconnect sonar control unit connector and front sonar sensor RH outer connector.
  3. Check continuity between sonar control unit harness connector and front sonar sensor RH outer connector
    Sonar control unitFront sonar sensor RH outerContinuity
    ConnectorTerminalConnectorTerminal
    B204E3072Existed
Is the inspection result normal?
.
Repair the harness or connector.
 
2.CHECK FRONT SONAR SENSOR RH OUTER GROUND CIRCUIT
Check continuity between sonar control unit harness connector and front sonar sensor RH outer harness connector.
Sonar control unitFront sonar sensor RH outerContinuity
ConnectorTerminalConnectorTerminal
B2013E3073Existed
Is the inspection result normal?
.
Repair the harness or connector.
 
3.CHECK REAR SONAR SENSOR SIGNAL LH OUTER
  1. Connect sonar control unit connector and front sonar sensor RH outer connector.
  2. Turn ignition switch ON.
  3. Check the signal between sonar control unit terminals as per the following condition.
    +−ConditionVoltage
    Sonar control unit
    ConnectorTerminalConnectorTerminal
    B204B2013
    • Shift position is in R position.
    • When the sensor is detecting an obstacle
Is the inspection result normal?
Replace the sonar control unit. Refer to Removal and Installation.
Replace the front sonar sensor RH outer. Refer to Removal and Installation.