[Previous][Next]
Electric Shift Warning Light
 
 
DESIGN/PURPOSE
The electric shift warning light illuminates when a malfunction occursin the electric shift control system.
 
 
BULB CHECK
For 2 seconds after the ignition switch is turned ON.
 
 
SYNCHRONIZATION WITH MASTER WARNING LIGHT
Not applicable
 
 
OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNAL
For actions on CAN communications blackout in the combination meter, refer to Fail-Safe.
 
 
SYSTEM DIAGRAM
 
 
SIGNAL PATH
  • The electric shift control module transmits an electric shift malfunction signal to the TCM when detecting malfunction in the electric shift system.
  • The TCM detects DTC when TCM receives an electric shift malfunction signal.
  • The TCM transmits an electric shift malfunction signal, a shift position signal, and a neutral hold mode signal to the combination meter when detecting DTC in TCM.
  • The ABS actuator and electric unit (control unit) transmits an electric parking brake status signal to the combination meter.
  • The combination meter turns ON the electric shift warning light according to each signal. Refer to
 
 
LIGHTING CONDITION
When any of the following conditions are satisfied.
  • Except neutral hold mode
  • Shift position is except P position
  • Electric shift system malfunction (Transmission does not shift to P position due to electric shift system malfunction)
  • Vehicle speed is less than 5 km/h(3 MPH)
  • Parking brake is not applied
 
 
SHUTOFF CONDITION
When any of the conditions listed below is satisfied:
  • In neutral hold mode
  • Shift position is P position
  • Electric shift system is normal
  • Vehicle speed is 5 km/h (3 MPH) or more
  • Parking brake is applied