[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
U1321–55Config unfinished
(Configuration unfinished)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)—
ThresholdConfiguration is incomplete
Diagnosis delay time—
 
 
POSSIBLE CAUSE
The configuration for combination meter is not done.
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Select “Self Diagnostic Result” mode of “METER M&A” using M.U.T.-III SE.
  4. Check DTC.
Is DTC "U1321-55" detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END