[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detected condition
U1010-49CONTROL UNIT (CAN)
[Control unit (CAN)]
Diagnosis conditionWhen ignition switch is ON.
Signal (terminal)—
ThresholdWhen detecting error during the initial diagnosis
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
Combination meter
 
 
FAIL-SAFE
The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.
Refer to Fail-Safe.
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait for 2 seconds or more.
  2. Check “Self Diagnostic Result” of “METER/M&A.”
Is DTC U1010-49 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END