[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detected condition
B220A-11Combination meter
(Combination meter)
Diagnosis conditionWhen ignition switch is ON.
Signal (terminal)Illumination control signal
ThresholdShort circuit
Diagnosis delay time2 secondes or more
 
 
POSSIBLE CAUSE
  • Combination meter
  • Harness or connectors
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait for 2 seconds or more.
  2. Check “Self Diagnostic Result” of “METER/M&A.”
Is DTC B220A-11 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END