[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detected condition
B220C-23Illumination up SW
(ILLUMINATION up switch)
Diagnosis conditionWhen ignition switch is ON.
Signal (terminal)Illumination control switch signal (+)
ThresholdSwitch stuck ON 5 minutes
Diagnosis delay time5 minutes or more
 
 
POSSIBLE CAUSE
  • Rotary light switch (illumination control switch)
  • Combination meter
  • Harness or connectors
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait for 5 minutes or more.
  2. Check “Self Diagnostic Result” of “METER/M&A.”
Is DTC B220C-23 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END