[Previous][Next]
Diagnosis Procedure
1.CHECK AMBIENT SENSOR SIGNAL
  1. Turn ignition switch ON.
  2. Check voltage between combination meter harness connector terminal and ground.
    +−Voltage
    Combination meter
    ConnectorTerminal
    M7629Ground
Is the inspection result normal?
.
.
 
2.CHECK AMBIENT SENSOR POWER SUPPLY
  1. Turn ignition switch OFF.
  2. Disconnect ambient sensor connector.
  3. Turn ignition switch ON.
  4. Check voltage between ambient sensor harness connector and ground.
    +−Voltage
    (Approx.)
    Ambient sensor
    ConnectorTerminal
    E761Ground5 V
Is the inspection result normal?
.
.
 
3.CHECK AMBIENT SENSOR GROUND CIRCUIT FOR OPEN
  1. Turn ignition switch OFF.
  2. Disconnect combination meter connector.
  3. Check continuity between ambient sensor harness connector and A/C auto amp harness connector.
    Ambient sensorCombination meterContinuity
    ConnectorTerminalConnectorTerminal
    E762M7630Existed
Is the inspection result normal?
.
Repair harness or connector.
 
4.CHECK AMBIENT SENSOR
Check ambient sensor. Refer to Component InspectionComponent Inspection.
Is the inspection result normal?
Replace combination meter Refer to Removal and Installation.
Replace ambient sensor. Refer to Removal and Installation.
 
5.CHECK AMBIENT SENSOR POWER SUPPLY CIRCUIT FOR OPEN
  1. Turn ignition switch OFF.
  2. Disconnect combination meter connector.
  3. Check continuity between ambient sensor harness connector and combination meter harness connector.
    Ambient sensorCombination meterContinuity
    ConnectorTerminalConnectorTerminal
    E761M7629Existed
Is the inspection result normal?
.
Repair harness or connector.
 
6.CHECK AMBIENT SENSOR POWER SUPPLY CIRCUIT FOR SHORT
Check continuity between ambient sensor harness connector and ground.
Ambient sensor—Continuity
ConnectorTerminal
E761GroundNot existed
Is the inspection result normal?
Replace combination meter Refer to Removal and Installation.
Repair harness or connector.
 
7.CHECK INTERMITTENT INCIDENT
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
Is the inspection result normal?
Replace combination meter Refer to Removal and Installation.
Repair or replace malfunctioning parts.