[Previous][Next]
Diagnosis Procedure
1.CHECK FUSE
Check for blown fuses.
Power sourceFuse No.
Battery29
Ignition switch ON or START 6
Is the inspection result normal?
Be sure to eliminate cause of malfunction before installing new fuse.
 
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector and ground.
TerminalsIgnition switch positionVoltage
(Approx.)
(+)(−)
Combination meterGround
ConnectorTerminal
M765OFFBattery voltage
6ON
Is the inspection result normal?
Check harness between combination meter and fuse.
 
3.CHECK GROUND CIRCUIT
  1. Turn ignition switch OFF.
  2. Disconnect combination meter connector.
  3. Check continuity between combination meter harness connector and ground.
    Combination meterGroundContinuity
    ConnectorTerminal
    M767Existed
Is the inspection result normal?
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
Repair harness or connector.