[Previous][Next]
Component Inspection
1.CHECK ILLUMINATION CONTROL SWITCH
  1. Turn ignition switch OFF.
  2. Disconnect illumination control switch connector.
  3. Check continuity between the following terminals of the illumination control switch.
    TerminalsConditionContinuity
    Illumination control switch
    64When illumination control switch (+) is pressedExisted
    Other than the aboveNot existed
    7When illumination control switch (−) is pressedExisted
    Other than the aboveNot existed
Is the inspection result normal?
INSPECTION END
Replace illumination control switch. Refer to Removal and Installation.