Diagnosis Procedure
1.
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
Sonar control unit
Is the inspection result normal?
.
Repair the terminal and connector.
2.
CHECK HARNESS FOR OPEN CIRCUIT
Disconnect the connector of sonar control unit.
Check the resistance between the sonar control unit harness connector terminals.
Sonar control unit harness connector
Resistance (Ω)
Connector No.
Terminal No.
B20
5
6
Approx. 54 – 66
Is the measurement value within the specification?
.
Repair the sonar control unit branch line.
3.
CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the sonar control unit. Refer to
Diagnosis Procedure
.
Is the inspection result normal?
(Present error)
Replace the sonar control unit. Refer to
Removal and Installation
.
(Past error)
Error was detected in the sonar control unit branch line.
Repair the power supply and the ground circuit.