[Previous][Next]
Removal and Installation
caution
If the silicon pad of the light and rain sensor which has been removed is in the following condition, do not reuse the light and rain sensor.
  • The silicon pad is deformed.
  • Dust is found on the surface of the silicon pad by visual check.
 
 
Removal Steps
1.Front camera cover
2.Light and rain sensor
 
 
REMOVAL SERVICE POINT
 
 
<<A>> LIGHT AND RAIN SENSOR REMOVAL
cautionWhen the sensor is removed, wipe off the silicon pad remaining on the windshield surface.
Disengage light and rain sensor fixing lock spring portion A, and then peel off rain light sensor.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< LIGHT AND RAIN SENSOR INSTALLATION
caution
  • Clean the sensor installation portion of the windshield.
  • When installing, never allow silicon pad to touch the sensor bracket and other parts.
  • Never use a sensor that is dropped.
  • Perform check after replacement. Refer to Component Function Check.
Compress the lock spring portion A vertically to the glass surface and fully engage both ends of lock spring.