[Previous][Next]
DISASSEMBLY AND REASSEMBLY
 
 
Disassembly steps
1.Mirror
2.Door mirror outer cover
3.Door mirror outer cover lower
4.Camera support <Vehicle with multi around monitor>
5.Side view camera <Vehicle with multi around monitor>
6.Side turn-signal light assembly
7.Actuator
8.Door mirror main wiring harness connector <Vehicles with electric folding door mirror>
9.Gasket
10.Base cover lower
11.Screw
12.Base
13.Rear view mirror retractor motor <Vehicles with electric folding door mirror>
14.Door mirror housing
    Required special tool:
  • MB990784: Ornament remover
 
 
DISASSEMBLY SERVICE POINTS
 
 
<<A>> MIRROR REMOVAL
Insert the ornament remover (Special tool: MB990784) in the mirror to remove it.
 
 
 
<<B>> DOOR MIRROR OUTER COVER LOWER REMOVAL
1. Remove door mirror outer cover lower fixing screws.
2. Disengage door mirror outer cover lower claw, and then remove door mirror outer cover lower.
 
 
 
 
REASSEMBLY SERVICE POINT
 
 
>>A<< DOOR MIRROR MAIN HARNESS CONNECTOR INSTALLATION
Check the wire color of the wiring harness, and insert it into the connector as shown in the illustration.
Terminal NoWire colorTerminal NoWire color
1Red/White9Light/Green
2Yellow/Black10Blue/Black
3White11Green
4-12Black/White
5Yellow13Pink
6Purple14Blue
7Black15Orange
8-16-