REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Front Fillet Molding/Rear Fillet Molding Removal and Installation (Refer to
REMOVAL AND INSTALLATION
).
Removal steps
1.
Front parting seal
2.
Rear parting seal
INSTALLATION SERVICE POINT
>>A<< REAR PARTING SEAL INSTALLATION
1.
Secure the grommets to the rear parting seal with screws.
2.
Secure the clips to the rear parting seal.
3.
Fit the lower side (grommets) of the rear parting seal to the body side, and then fit the upper side (clips).