Adjustment

	Rear sunroof glass		Glass lid		Roof panel
	: Vehicle front

If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.

note	Standard of surface height is given assuming that the glass upper side status is (+), and the glass lower side status is (−) relative to the roof panel.

Unit: mm [in]

Portion				Standard
Roof panel – Rear sunroof glass	–	E	Clearance	6.3 – 7.9 [0.249 – 0.311]
	–	F	Surface height	(+0.2) – (+1.9) [(+0.008) – (+0.074)]
	–	G	Clearance	6.3 – 7.9 [0.249 – 0.311]
	–	H	Surface height	(+0.2) – (+1.9) [(+0.008) – (+0.074)]
Roof panel – Glass lid	–	I	Clearance	6.3 – 7.9 [0.249 – 0.311]
	–	J	Surface height	(+0.2) – (+1.9) [(+0.008) – (+0.074)]
	–	K	Clearance	6.3 – 7.9 [0.249 – 0.311]
	–	L	Surface height	(+0.2) – (+1.9) [(+0.008) – (+0.074)]

1. Loosen rear sunroof glass fixing screws.

2. Adjust the clearance of rear sunroof glass and roof panel according to the fitting standard dimension.

3. To prevent rear sunroof glass from moving after adjustment, first tighten the fixing screw of front left, and then tighten the fixing screw of rear right.

4. Tighten remaining fixing screws, being careful to prevent rear sunroof glass from moving.

note	After adjustment the sunroof unit assembly, perform additional service. Refer to Work Procedure.