[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove rear sunroof glass. Refer to Removal and Installation.
2. Disengage sunshade stay using a remover tool (A) from sunshade slider as shown by the arrow in the figure.
cautionApply protective tape (B) on remover tool to protect parts from damage.
: Vehicle front
3. Push sunshade stay according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove sunshade stay from sunshade slider .
: Vehicle front
4. Disengage sunshade base fixing pawl using a remover tool (A).
5. Remove sunshade base and rollshade stay, sunshade as a unit.
6. Disengage sunshade fixing paw according to numerical order 1→2 indicated by arrows as shown in the figure, and then remove sunshade from sunshade base.
cautionWhen removing, insert a pin etc. into the hole to lock spring stopper.
7. Remove rollshade stay from sunshade base.
 
 
INSTALLATION
 
 
1. Install rollshade stay to sunshade base.
2. Install sunshade to sunshade base.
caution
  • When installing, remove a pin etc. to unlock spring stopper.
  • If spring tension becomes loose, turn spring stopper about 18.5 times while fixing sunshade so that it does not move, and then install.
3. Install sunshade base and rollshade stay, sunshade as a unit to sunroof frame assembly.
4. Install sunshade stay to sunshade slider.
note After installation sunshade assembly, perform additional service. Refer to Description.