[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC detecting condition
B2C20-12Starter control relay
(Starter control relay)
Diagnosis conditionIgnition switch ON
Signal (terminal)Starter cut relay signal
ThresholdWhen BCM detects starter cut relay circuit is short to buttery
Diagnosis delay time1 second or less
 
 
POSSIBLE CAUSE
  • Harness or connectors
    (Starter cut relay circuit is short to battery)
  • Starter cut relay
 
 
FAIL-SAFE
—
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
  1. Press push-button ignition switch under the following conditions and wait 1 second or more.
    • Selector lever: In the P position.
    • Brake pedal: Depressed.
  2. Select “Self Diagnostic Result” mode of “BCM” using M.U.T.-III SE.
Is the DTC detected?
Refer to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END