[Previous][Next]
Key ID Verification Information
 
 
DESIGN/PURPOSE
If the system cannot detect a registered Keyless operation key inside the vehicle, it informs the driver that it is necessary for the vehicle to detect a registered Keyless operation key.
SymbolMessage
 
 
SYNCHRONIZATION WITH MASTER WARNING LIGHT
No applicable
 
 
SYSTEM DIAGRAM
 
 
SIGNAL PATH
  • Keyless operation key unit activates inside key antenna and checks that Keyless operation key is in vehicle, when push-button ignition switch operation is performed while ignition switch position is OFF.
  • When Keyless operation key unit does not detect a registered Keyless operation key in vehicle, meter display signal is transmitted by Keyless operation key unit to combination meter via CAN communication.
  • When combination meter receives meter display signal, key ID verification information displays.
 
 
WARNING/INDICATOR OPERATION CONDITION
When all of the following conditions are satisfied.
  • Ignition switch is OFF position.
  • Push-button ignition switch operation is performed.
  • Registered Keyless operation key is not detected inside the vehicle.
 
 
WARNING/INDICATOR CANCEL CONDITION
When any of the following conditions are satisfied.
  • After 5 seconds are passed since the key ID verification information is displayed.
  • When Keyless operation key backside is contacted to push-button ignition switch while brake pedal is depressed. And then turn ignition switch ON.
  • Registered Keyless operation key is detected inside the vehicle.