[Previous][Next]
Engine Start Information
 
 
DESIGN/PURPOSE
Information display informs the driver that the engine can be started.
SymbolMessage
Push brake and start switch to drive
 
 
SYNCHRONIZATION WITH MASTER WARNING LIGHT
No applicable
 
 
SYSTEM DIAGRAM
 
 
SIGNAL PATH
  • Keyless operation key unit receives engine status signal from ECM via CAN communication and checks that the engine can be started.
  • When Keyless operation key unit detects that the engine can be started, meter display signal is transmitted by Keyless operation key unit to combination meter via CAN communication.
  • When combination meter receives meter display signal, engine start information displays.
 
 
WARNING/INDICATOR OPERATION CONDITION
 
 
When Ignition Switch is ON.
When all of the following conditions are satisfied.
  • Ignition switch is in ON position.
  • Shift position: P position.
  • Engine can be started.
 
 
When Ignition Switch is Other Than ON.
When all of the following conditions are satisfied.
  • One condition of A
  • All conditions of B
    A conditionB condition
    • Any door is open → All door is closed
    • Push-button ignition switch: Pressed
    • Keyless operation key backside is contacted to push-button ignition switch while brake pedal is depressed.
    • Ignition switch: OFF position
    • Shift position: P position
    • Registered Keyless operation key is detected inside vehicle.
 
 
WARNING/INDICATOR CANCEL CONDITION
 
 
When Ignition Switch is ON.
When any of the following conditions are satisfied.
  • Engine is started.
  • Shift position: Other than P position.
 
 
When Ignition Switch is Other than ON.
When any of the following conditions are satisfied.
  • Shift position: Other than P position.
  • Registered Keyless operation key is not detected inside the vehicle.
  • When Keyless operation key unit receives Keyless operation key button operation via remote keyless entry receiver.
  • When Keyless operation key unit receives door request switch signal from door request switch.
  • After 15 seconds are passed since the engine start information is displayed.