DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H-line, CAN L-line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart

DTC DETECTION LOGIC

DTC No.	M.U.T.-III SE screen items (Trouble diagnosis content)	DTC Detection Condition
U215B-86	CAN comm err (IPDM E/R) [CAN communication error (IPDM E/R)]	Diagnosis condition	Ignition switch ON
		Signal (terminal)	CAN communication signal
		Threshold	Transmission error or reception error
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAG RESULT

With M.U.T.-III SE

Ignition switch ON and wait for 2 seconds or more.
Check “Self Diagnostic Result” mode of “HANDS FREE MODULE” using M.U.T.-III SE.

Is DTC detected?

Refer to DTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END