[Previous][Next]
Work Procedure
1.REPLACE DRIVER SEAT CONTROL UNIT
Replace driver seat control unit. Refer to Removal and Installation.
Which is the vehicle specification?
:
: .
 
2.VEHICLE SPECIFICATION RECOGNITION
  1. Connect battery negative terminal.
  2. Ignition switch ON and wait for 30 seconds or more.
    noteWhen the driver seat control unit receives a signal from the AV control unit for 30 seconds after the battery is energized, it is recognized and set as the specifications of with navigation system.
:
 
3.LOG-IN STORING
Perform log-in storing. Refer to System Description.
: .
 
4.MEMORY STORING
Perform memory storing. Refer to Description.
Which is the vehicle specification?
: WORK END
: .
 
5.INTELLIGENT KEY INTERLOCK STORING
Perform Keyless operation key interlock storing. Refer to Description.
: WORK END