[Previous][Next]
System Description
 
 
SYSTEM DIAGRAM
ComponentFunction
Sliding motor LHSliding motor
  • Sliding motor is activated with driver seat control unit.
  • Slides the seat forward/backward by changing the rotation direction of sliding motor.
Sliding sensor
  • Sliding sensor is integrated in sliding motor
  • The pulse signal is input to driver seat control unit when sliding is performed.
  • Driver seat control unit counts the pulse and calculates the sliding amount of the seat.
BCMRecognizes the following status and transmits it to driver seat control unit via CAN communication.
  • Ignition ON signal
  • Key ID signal
ABS actuator and electric unit (control unit)ABS actuator and electric unit (control unit) transmits the vehicle speed signal to driver seat control unit via CAN communication.
Driver seat control unitRefer to Driver Seat Control Unit.
 
 
DESCRIPTION
  • This function allows the driver side seat to return from the exiting position to the position before the exiting function is operated when the ignition switch is operated from OFF to ON when the driver enters the vehicle.
  • If the ignition switch is operated with any Keyless operation key other than that used before the exiting function is operated, the driver side seat will return to the driver position registered for that Keyless operation key.
note
  • This function is set to ON before delivery (initial setting).
  • Further information for the system setting procedure. Refer to Description.
 
 
Operation Condition
  1. Ignition switch ON.
  2. Driver seat will return from the exiting position to entry position.
 
 
Operation Procedure
Satisfy all of the following items. The entry assist function is not performed if these items are not satisfied.
ItemStatus
SeatThe vehicle is not moved after performing the exit assist function.
Switch inputs
  • Power seat switch
  • Door mirror remote control switch
  • Set switch
  • Memory switch
OFF
(Not operated)
Vehicle speed0 Km/h (0 MPH)
M.U.T.-III SENot connected
 
 
Detail Flow
OrderInputOutputControl unit condition
1Ignition switchDriver seat control unit receives the signals of ignition ON signal from BCM via CAN communication.
2Motors
(Sliding)
Driver seat control unit operates the sliding motor when the operating conditions are satisfied.
3Sensors
(Sliding)
Sliding sensor monitors the operating positions of seat, and then stops the operation of sliding motor when seat reaches the recorded positions.