[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Removal steps
1.Floor console pad
2.Console finisher assembly
3.Electric parking brake switch
4.Drive mode select switch
5.Gearshift lever panel
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> FLOOR CONSOLE PAD REMOVAL
Use ornament remover (Special tool: MB990784) to disengage the clips and remove the floor console pad by pulling it in the direction shown.
 
 
 
<<B>> CONSOLE FINISHER ASSEMBLY REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<C>> DRIVE MODE SELECT SWITCH/GEARSHIFT LEVER PANEL REMOVAL
cautionIf the drive mode select switch is removed, the console finisher assembly or the drive mode select switch may be damaged. Do not remove the drive mode select switch except when replacing parts.