[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B24A2-55Configuration not implement
(Configuration not implement)
Diagnosis conditionIgnition switch ON
Signal (Terminal)—
ThresholdVehicle specification is not written
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
Configuration is not completed
 
 
FAIL-SAFE
—
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF-DIAGNOSIS
With M.U.T.-III SE
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “HVAC” using M.U.T.-III SE.
  3. Check DTC.
Is DTC detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END