[Previous][Next]
Work Procedure
1.STEERING TORQUE SENSOR CALIBRATION
With M.U.T.-III SE
  1. Ignition switch ON.
  2. Select "EPS/DAST 3".
  3. Select "Special function".
  4. Select "Learning".
  5. Select and run "Torque sensor neutral position learning".
    caution
    • Make sure that the tires and the steering wheel are in the straight-ahead position.
    • Do not apply torque to the steering wheel while the learning process is executed.
  6. Ignition switch OFF to ON.
  7. Wait 5 seconds.
  8. Ignition switch OFF to ON.
  9. Erase self-diagnostic results for “EPS/DAST 3”.
  10. Pull the parking brake switch.
    noteCheck the parking brake switch indicator is turn On.
  11. Ignition switch OFF.
  12. Get out of the vehicle and close all doors.
  13. Wait 65 seconds.
    note
    • Check the parking brake switch indicator turn OFF.
    • If the rear brake caliper is heated, wait an hour so that parking brake switch indicator does not turn OFF.
  14. Ignition switch ON.
  15. Perform self-diagnosis for “EPS/DAST 3”.
Is DTC C1608-46 or C160B-54 detected?
Ignition switch OFF once, and then repeat the procedure from the start.
Work End