[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C105842Control unit
(Control unit)
Diagnosis condition
  • When ignition switch is ON.
  • When the power supply voltage is normal.
Signal (terminal)-
ThresholdWhen there is an internal malfunction in the ABS actuator and electric unit (control unit).
Diagnosis delay time2 seconds or less
 
 
POSSIBLE CAUSE
noteConfirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.
PAST DTCCRNT DTC
  • The vehicle travels near high-voltage electrical power lines.
  • Motor built in the ABS actuator and electric unit (control unit) operates temporarily without a break.
  • Harness or connector
  • ABS actuator and electric unit (control unit) power supply system
  • Fuse
  • Fusible link
  • 12V battery
  • Incomplete adjustment of steering angle sensor neutral position.
  • Harness or connector
  • ABS actuator and electric unit (control unit)
  • ABS actuator and electric unit (control unit) power supply system
  • Fuse
  • Fusible link
  • 12V battery
 
 
FAIL-SAFE
The following functions are suspended.
  • ASC function
  • TCS function
  • ABS function
  • EBD function
  • Brake limited slip differential (BLSD) function
  • Brake assist function
  • Brake force distribution function
  • hill start assist function
  • Electric parking brake function
  • Hill Decent Control function
  • Trailer Stability Assist (TSA) function
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.
: .
 
2.CHECK DTC DETECTION
With M.U.T.-III SE
  1. Ignition switch OFF (Auto ACC function OFF).
  2. Start the engine.
    noteWait at least 10 seconds after start the engine.
  3. Perform self-diagnosis for “ABS”.
Is DTC “C1058-42” detected?
-1“Active DTC” is displayed: Refer to Diagnosis Procedure.
-2“Stored DTC” is displayed: INSPECTION END (Erase the memory of self-diagnosis results.)
-1To check malfunction symptom before repair: Refer to Intermittent Incident Intermittent Incident.
-2Confirmation after repair: INSPECTION END