Diagnosis Procedure

[Previous]

[Next]

Diagnosis Procedure

1.CHECK REAR BRAKE COMPONENT PARTS

Apply and release the parking brake.
Disconnect 12V battery negative terminal
Check rear brake component parts.
- Rear brake pad: Refer to Inspection and AdjustmentInspection and Adjustment.
- Rear brake caliper assembly and parking brake actuator: Refer to Inspection and AdjustmentInspection and Adjustment.
- Rear disc rotor: Refer to Inspection and AdjustmentInspection and Adjustment.

Is the inspection result normal?

.

Repair or replace error-detected parts.

.

2.PERFORM SELF-DIAGNOSIS

With M.U.T.-III SE

Connect 12V battery negative terminal.
Ignition switch ON.
caution Be sure wait of 10 seconds after ignition switch ON.
Apply and release the parking brake five times.
Perform self-diagnosis for “ABS”.

Is DTC “C10B8-77” detected?

-1"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation

.

-2“Stored DTC” is displayed: INSPECTION END (Erase the memory of self-diagnosis results.)

INSPECTION END