Diagnosis Procedure
1.
CHECK REAR BRAKE COMPONENT PARTS
Apply and release the parking brake.
Disconnect 12V battery negative terminal.
Check rear brake component parts.
Rear brake pad: Refer to Inspection and Adjustment
Inspection and Adjustment
.
Rear brake caliper assembly and parking brake actuator: Refer to Inspection and Adjustment
Inspection and Adjustment
.
Rear disc rotor: Refer to Inspection and Adjustment
Inspection and Adjustment
.
Is the inspection result normal?
.
Repair or replace error-detected parts.
.
2.
PERFORM SELF-DIAGNOSIS
With M.U.T.-III SE
Connect 12V battery negative terminal.
Ignition switch ON.
caution
Be sure wait of 10 seconds after ignition switch ON.
Apply and release the parking brake five times.
Perform self-diagnosis for “ABS”.
Is DTC “C10B6–68” detected?
-1
"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to
Removal and Installation
.
-2
“Stored DTC” is displayed: INSPECTION END (Erase the memory of self-diagnosis results.)
INSPECTION END