[Previous][Next]
Diagnosis Procedure
1.PROGRAMING OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Perform programing of ABS actuator and electric unit (control unit). Refer to Work Procedure.
: .
 
2.PERFORM SELF-DIAGNOSIS
With M.U.T.-III SE
  1. Ignition switch ON.
    cautionBe sure wait of 10 seconds after ignition switch ON.
  2. Perform self-diagnosis for “ABS”.
Is DTC “C10B3-68” detected?
-1"CRNT" is displayed: Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
-2“Stored DTC” is displayed: INSPECTION END (Erase the memory of self-diagnosis results.)
INSPECTION END