[Previous][Next]
Disassembly and Assembly
 
 
DISASSEMBLY
caution
  • Never disassemble the cylinder body.
  • Remove the reservoir tank only when necessary.
  • Never drop parts to remove. Replace new parts when dropping.
 
 
1. Fix the master cylinder assembly to a vise.
caution
  • Always set copper plates or cloth between vise grips when fixing the cylinder body to a vise.
  • Never overtighten the vise.
2. Remove the reservoir tank pin.
3. Remove the reservoir tank and grommet from the cylinder body.
 
 
ASSEMBLY
caution
  • Never use mineral oils such as kerosene or gasoline and rubber grease during the cleaning and assembly process.
  • Never allow foreign matter (e.g. dust) and oils other than brake fluid to enter the reservoir tank.
  • Never drop when installing. The parts must not be reused if they are dropped.
 
 
1. Apply new brake fluid to the grommet and install it to the cylinder body.
cautionNever reuse grommets.
2. Install the reservoir tank to the cylinder body.
3. Fix the cylinder body to a vise.
caution
  • Always set copper plates or cloth between vise grips when fixing the cylinder body to a vise.
  • Never overtighten the vise.
4. Insert the pin.