[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C170054Control unit
(Control unit)
Diagnosis conditionWhen Ignition switch is ON.
Signal (terminal)–
ThresholdTire pressure monitoring system configuration has not been performed.
Diagnosis delay time1 second or less.
 
 
POSSIBLE CAUSE
  • Configuration is not completed.
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
With M.U.T.-III SE
Perform “Self-diagnosis” of “BCM”.
Is DTC “C1700-54” detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END