Removal and Installation

REMOVAL

1. Remove tires. Refer to Removal and InstallationRemoval & Installation

2. Remove parking brake actuator harness and rear wheel sensor. Hang parking brake actuator harness and rear wheel sensor not to interfere with work. Refer to Removal and Installation

3. Remove caliper assembly. Hang caliper assembly in a place where it will not interfere with work. Refer to Removal and Installation

caution

Never depress brake pedal while brake caliper is removed.

4. Remove disc rotor.

caution

Put matching marks on the wheel hub and bearing assembly and the disc rotor before removing the disc rotor.
Never drop disc rotor.

5. Remove wheel hub and bearing assembly mounting bolts

6. Remove wheel hub and bearing assembly and back plate.

7. Remove radius rod. Refer to Removal and Installation

8. Remove front lower link. Refer to Removal and Installation

9. Remove coil spring. Refer to Removal and Installation

10. Remove rear suspension arm mounting bolts

and nuts

from axle housing

11. Separate rear suspension arm, and then remove axle housing.

12. Remove hub bolts

from wheel hub and bearing assembly, using the ball joint remover (A) (commercial service tool).

caution

Remove hub bolt only when necessary.
Never hammer the hub bolt to avoid impact to the wheel hub and bearing assembly.
Pull out the hub bolt in a direction perpendicular to the wheel hub and bearing assembly.

13. Perform inspection after removal. Refer to Inspection

INSTALLATION

Note the following, and install in the reverse order of removal.

Place a washer as shown in the figure to install the hub bolts by using the tightening force of the nut .
caution
Check that there is no clearance between wheel hub and bearing assembly and hub bolt.
Never reuse hub bolt.
Align the matching marks made during removal when reusing the disc rotor.
Perform inspection after installation. Refer to Inspection.