[Previous][Next]
Refilling
 
 
1. Fill with new transfer oil until oil level reaches the specified level near filler plug mounting hole, after removing filler plug and gasket from transfer assembly.
: Vehicle front
Recommended oil and capacity: Refer to Fluids and Lubricants.
2. Rotate the propeller shaft or drive shafts slowly by hand to penetrate the transfer oil inside of transfer assembly.
3. Leave the vehicle for 3 minutes, and check the oil level again.
4. Set a gasket on filler plug, and install it to transfer assembly.
cautionNever reuse gasket.
5. Tighten filler plug to the specified torque. Refer to Exploded View.