[Previous][Next]
Removal and Installation
 
 
REMOVAL
cautionBe sure that vehicle does not move before removing shift actuator.
  • Apply the parking brake.
  • Shift to the P position (if electric shift system is normal).
 
 
1. Disconnect the negative battery terminal. Refer to Exploded View.
2. Remove air duct and air cleaner. Refer to Exploded View.
3. Remove bolt and remove harness bracket .
4. Disconnect the harness connectors from the shift actuator.
5. Remove bolts from shift actuator and remove shift actuator.
 
 
INSTALLATION
cautionApply the parking brake.
cautionNote when the shift actuator is removed while the range is in the P position, and installed while the range is in the N position:
  • Never use remote engine start system immediately after installing shift actuator.
  • Adjust to P range after pressing P switch without operating shift selector after ignition switch ON.
  • Unless the above points are performed, the electric shift control module does not accept the request from the shift lever.
 
 
1. Clean splines of manual shaft and shift actuator before installing shift actuator.
2. Apply grease evenly to the shift actuator spline .
: Lithium-based grease including molybdenum disulphide
3. Install the shift actuator to the transaxle assembly.
4. Tighten bolts to the specified torque.
5. Connect the harness connectors to the shift actuator.
6. Install harness to bracket.
7. Install air duct and air cleaner. Refer to Exploded View.
8. Connect the negative battery terminal. Refer to Exploded View.
9. Turn the ignition switch ON and press the P position switch.
10. Turn the ignition switch OFF.
11. Perform inspection after installation. Refer to Inspection.