[Previous][Next]
Electric Shift Warning
 
 
DESIGN/PURPOSE
 
 
Electric Shift Warning
This message warns the driver that electric shift system is not normal.
 
 
Shift Position Warning
This message informs the driver that the selector lever is in between positions.
 
 
SYNCHRONIZATION WITH MASTER WARNING LIGHT
Applicable
 
 
SYNCHRONIZATION WITH WARNING BUZZER
Applicable
For warning buzzer, refer to Electric Shift Warning (Buzzer).
 
 
OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNAL
For actions on CAN communications blackout in the combination meter, refer to Fail-Safe.
 
 
SYSTEM DIAGRAM
 
 
SIGNAL PATH
  • The electric shift control module transmits an electric shift malfunction signal to the TCM when detecting a malfunction in the electric shift system.
  • TCM detects DTC when TCM receives an electric shift malfunction signal.
  • TCM transmits an electric shift warning message signal to the combination meter when detecting DTC in TCM.
  • The combination meter displays the each message according to the electric shift warning message signal.
 
 
WARNING/INDICATOR OPERATING CONDITION
 
 
Electric Shift Warning
When all of the following conditions are satisfied at ignition ON:
  • Parking brake is not applied
  • When the electric shift system detects DTC of master warning light
  • Vehicle speed: Less than 5 km/h (3 MPH)
When all of the following conditions are satisfied at ignition OFF:
  • Except neutral hold mode
  • Shift position: Except P position
  • Parking brake is not applied
  • When the electric shift system detects DTC of master warning light (red)
 
 
Shift Position Warning
When selector lever is in between positions for 1 second.
 
 
WARNING/INDICATOR CANCEL CONDITION
 
 
Electric Shift Warning
When any of the following conditions are satisfied.
  • After operating the parking brake with the ignition ON, turn OFF the ignition switch.
  • Erase DTC
  • Vehicle speed 5 km/h (3 MPH) of more
 
 
Shift Position Warning
Optimizing selector lever position