DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P07EF	00	T/M RANGE SELECTOR (Transmission Range Multi-Function Select Circuit Low)	Diagnosis condition	When the ignition switch is ON
			Signal	Electric shift sensor signal
			Threshold	All electric shift sensors No. 1 to No. 8 are OFF.
			Diagnosis delay time	—

Shift position judgment table

Selector lever position	Electric shift sensor
Selector lever position	No. 1	No. 2	No. 3	No. 4	No. 5	No. 6	No. 7	No. 8
R	ON	ON	OFF	OFF	OFF	OFF	OFF	OFF
Nr	ON	ON	ON	ON	ON	OFF	OFF	OFF
H	ON	ON	ON	ON	ON	ON	ON	ON
Nd	OFF	OFF	OFF	ON	ON	ON	ON	ON
D/M	OFF	OFF	OFF	OFF	OFF	OFF	ON	ON

POSSIBLE CAUSE

Electric shift control module
Electric shift sensor
Harness or connectors (Electric shift sensor circuit is open or shorted.)

FAIL-SAFE

Powertrain becomes neutral

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

The ignition switch is ON and wait for 10 seconds or more.
Check DTC.

Is "P07EF-00" detected?

Go to DTC Diagnosis Procedure

-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END