[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P07ED00T/M RANGE SELECT
(Transmission Range Multi-Function Select Circuit Stuck)
Diagnosis conditionWhen the ignition switch is ON
SignalElectric shift sensor signal
ThresholdTwo or more sensors out of electric shift sensors No. 1 to No. 8 are stuck at ON or OFF.
Diagnosis delay time
Shift position judgment Table
Selector lever positionElectric shift sensor
No. 1No. 2No. 3No. 4No. 5No. 6No. 7No. 8
RONONOFFOFFOFFOFFOFFOFF
NrONONONONONOFFOFFOFF
HONONONONONONONON
NdOFFOFFOFFONONONONON
D/MOFFOFFOFFOFFOFFOFFONON
 
 
POSSIBLE CAUSE
  • Electric shift sensor
  • Harness or connectors (Electric shift sensor circuit is open or shorted.)
 
 
FAIL-SAFE
  • Powertrain becomes neutral
  • Shift to P, R, N, and D position is prohibited
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON.
  2. Select "Data List" in "SHIFT".
  3. Select "Shift position judgment".
  4. Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)
    H → Nr → R → Nd → D/M → H
  5. Repeat step 4 five times.
  6. Check DTC.
Is "P07ED-00" detected?
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END