DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P0718	00	INPUT SPEED SENSOR A (Input/Turbine Shaft Speed Sensor "A" Circuit Intermittent)	Diagnosis condition	TCM power supply voltage: More than 11 V
			Signal	—
			Threshold	Input speed: more than 7750 rpm
			Diagnosis delay time	2 seconds

POSSIBLE CAUSE

Harness or connector (Input speed sensor circuit is open or shorted)
Input speed sensor
TCM

FAIL-SAFE

Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

caution

Always drive vehicle at a safe speed.

1.PRECONDITIONING

If "DTC CONFIRMATION PROCEDURE" is previously conducted, always the ignition switch is OFF and wait at least 10 seconds before performing the next test.

2.CHECK DTC DETECTION

Start the engine.
Shift to D position.
Fully depress the accelerator pedal and accelerate by reaching 80 – 100 km/h (50 – 62 MPH).
And then release the accelerator pedal.
caution
Never exceed legal speed.
Always drive at a safe speed.
Stop the vehicle.
Check the first trip DTC.

Is "P0718–00" detected?

Go to Diagnosis ProcedureDTC Diagnosis Procedure

-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END