[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P091900GEAR SHIFT POSITION
(Gear Shift Position Control Error)
Diagnosis conditionWhen the ignition switch is ON
Signal
ThresholdThe output of the shift actuator does not stop.
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Transaxle assembly
  • Shift actuator
 
 
FAIL-SAFE
Shifting operation is prohibited
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Depress the brake pedal.
  3. Shift the selector lever to D/M position and wait for 10 seconds.
  4. Press the P position switch and wait for 10 seconds.
  5. Check DTC.
Is “P0919-00 detected?
Go to Diagnosis ProcedureDiagnosis Procedure.
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END