[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P091500GEAR SHIFT POSITION
(Gear Shift Position Circuit Range/Performance)
Diagnosis conditionWhen the ignition switch is ON
SignalEncoder signal A and B
ThresholdEncoder signals are not transmitted despite the actuation of parking actuator by the electric shift control module.
Diagnosis delay time
 
 
POSSIBLE CAUSE
  • Harness or connectors (Encoder circuit is open or shorted.)
  • Encoder (shift actuator)
  • Electric shift control module
 
 
FAIL-SAFE
  • Shifting operation is prohibited
  • Powertrain becomes neutral
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Start the engine.
  2. Depress the brake pedal.
  3. Shift the selector lever to “R” position and wait for 10 seconds.
  4. Shift the selector lever to “Nd” position and wait for 10 seconds.
  5. Shift the selector lever to “D/M” position and wait for 10 seconds.
  6. Press the P position switch and wait for 10 seconds.
  7. Check DTC.
Is “P0915-00 detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END