[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P07EE*00T/M RANGE SELECTOR
(Transmission Range Multi-Function Select Circuit Range/Performance)
Diagnosis conditionWhen the ignition switch is ON
SignalElectric shift sensor signal
ThresholdThe electric shift sensor signal which the electric control module receives is abnormal.
Diagnosis delay time
*: This code is displayed as P0914 on GST.
 
 
POSSIBLE CAUSE
Electric shift control module
 
 
FAIL-SAFE
  • Shifting operation is prohibited
  • Powertrain becomes neutral
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON.
  2. Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)
    H → Nr → R → Nd → D/M → H
  3. Check DTC.
Is “P07EE-00 detected?
Go to Diagnosis ProcedureDTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END